It is currently Sat 19 Oct 2019, 5:15 pm

All times are UTC + 10 hours




Post new topic Reply to topic  [ 42 posts ]  Go to page Previous  1, 2, 3
Author Message
PostPosted: Mon 26 Dec 2016, 4:39 pm 
Offline
Member
Member

Joined: Mon 26 Dec 2016, 4:02 pm
Posts: 1
Gender: Male
Your car: 1983 1800 non turbo cordia
ok guys and girls this question would of been asked a million times before but have just joined one of the kids has 83 non turbo 1800 cordia when its hot and you go to start it it only starts when you let the key go. the coil was replaced as it was leaking oil but the new coil gets very hot. is this normal it has no ballest resistor. have recently only purchased it and it had been parked up in a barn for the last 15 years thank you


Top
 Profile  
Reply with quote  
PostPosted: Mon 26 Dec 2016, 4:47 pm 
Offline
This forum is my life
This forum is my life
User avatar

Joined: Fri 09 Jun 2006, 11:35 pm
Posts: 3642
Location: Adelaide South Australia
Gender: Male
Your car: DOHC 2.3 VR4 85 AB GSR
Immaculate Stock 86 AC GSR
You need a ballast resistor for the coil..........they don't like seen 12volt.........and 8ohm one will help, this will reduce voltage to ensure the coil and the points don't burn!


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 42 posts ]  Go to page Previous  1, 2, 3

All times are UTC + 10 hours


Who is online

Users browsing this forum: No registered users and 8 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron



Connect with Cordia Power on Facebook. Cordia Power 2000-2018. Cordia Forum powered by phpBB.