Hey guys

Anyone got a pinout or wiring diagram for the above dizzy. Just wiring in a stinger to my cordia and dont want to fry anything.

Cheers
Pete

that would be handy for a sticky

_________________
AA Silver saved,4g62t SOHC,Td05,FMIC
AB Silver bullet in the build, 4G62T DOHC
AB Silver original unrestored 1 owner car
AC Wanted $$$(must have 4g62t, or I can swap it back)

last cordia:
Blue 88 GSR turbo AC with 62t, TD05 14B and FMIC
(I WOULD LIKE IT BACK IF POSSIBLE, OLD REG SYH354)

From the module the colours should be:
Red is +12, Black is ground, yellow is reference signal (trigger) and white is sync.

The stinger runs:
Green = Trig, Yellow = sync, Red = +12v and Blue = GND.

The ecu may need a resistor, the wolf needed one, but check the ems installation manual.

cheers Andrew

_________________
AA Silver saved,4g62t SOHC,Td05,FMIC
AB Silver bullet in the build, 4G62T DOHC
AB Silver original unrestored 1 owner car
AC Wanted $$$(must have 4g62t, or I can swap it back)

last cordia:
Blue 88 GSR turbo AC with 62t, TD05 14B and FMIC
(I WOULD LIKE IT BACK IF POSSIBLE, OLD REG SYH354)

Cheers for that.
In my case the sonata dizzy had the connector assy missing (just blank terminals on the dizzy with no markings) so I basically had to screw around with a multimeter and power supply for a while until I identified what was what. Luckily I got it sussed without frying anything. I will post a pic soon showing the pin layout for anyone else that ends up in the same boat. Any yep you gotta turn the pull-up resistors on in the ecu setup menu or the ecu won't detect the trigger or sych hall sensor signals.
Cheers
Pete

hey mate,
Im looking for one of these dizzys myself.... what model/year car should i get one from??

Cheers Steve