Cordia Forum https://www.cordiapower.com/forum/ |
|
Factory Oil Cooler Mounting https://www.cordiapower.com/forum/viewtopic.php?f=4&t=17892 |
Page 1 of 1 |
Author: | 0-PSI [ 15 Jan 2016, 18:32 ] |
Post subject: | Factory Oil Cooler Mounting |
Hey guys, I'm chasing a clear photo of how the factory oil cooler is mounted to the support bar. Unfortunately I have lost a lot of old photos for references, thanks to my PC deleting them. Appreciate the help. Cheers, Mike |
Author: | 0-PSI [ 16 Jan 2016, 04:54 ] |
Post subject: | Re: Factory Oil Cooler Mounting |
Hey Andrew, good to hear from you. Thanks for chiming in. No chance did you have a photo of the cooler mounted? I took mine out of storage today as I have the front of the car apart, however upon lining it up to the crossmember to where it would mount there doesn't seem to be provision for one on the GSL. No mounting holes, unless I've missed something. Which I thought was strange as it would have made sense to use the same crossmember across the whole range. May have to pay the wreckers a visit yet so as to keep this conversion as factory as possible rather than drilling new mounting holes. |
Author: | 0-PSI [ 16 Jan 2016, 12:53 ] |
Post subject: | Re: Factory Oil Cooler Mounting |
Thanks Andrew, I'll have to make something up for it to mount to. Photo taken of the GSL: |
Author: | Bitza [ 16 Jan 2016, 13:21 ] |
Post subject: | Re: Factory Oil Cooler Mounting |
Well that's a bastard! |
Author: | 0-PSI [ 16 Jan 2016, 14:45 ] |
Post subject: | Re: Factory Oil Cooler Mounting |
My exact thoughts Andrew! I won't worry about it now until the new engine is in. |
Page 1 of 1 | All times are UTC + 10 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |