Cordia Forum
https://www.cordiapower.com/forum/

Injector advice
https://www.cordiapower.com/forum/viewtopic.php?f=4&t=21233
Page 1 of 1

Author:  ScrubbRacer [ 29 Jan 2018, 09:07 ]
Post subject:  Injector advice

Hi guys,

Don't have a Cordia, but rather a Lancer EX with a G62B Turbo engine - same as Cordias.

I was hoping someone can tell me the rating, part numbers, or alternative parts for the stock injectors as I'd like to replace mine with new ones. My engine has the 'B-Type' injection setup as shown below and is a 1987 model if that helps:

Image

Appreciate any comments or advice, thanks!

Author:  Wexx [ 01 Feb 2018, 02:24 ]
Post subject:  Re: Injector advice

http://www.racetronix.biz/itemdesc.asp? ... 42&eq=&Tp=

Try to find a spare fuel rail to modify. You will need to enlarge the injector holes a bit and take the filters out since the newer injectors have filters in the feed ends. You will also need some spacers to raise the fuel rail up with longer bolts. I think the connectors are the same. I'll be doing this mod to my Cordia soon.

Rob

Author:  ScrubbRacer [ 12 Feb 2018, 19:07 ]
Post subject:  Re: Injector advice

Thanks Wexx, I'm ideally looking for something to fit without mods, but I'll hit those guys up if I need to go that route :)

So it seems that they're both likely ~800cc each? I think I read somewhere that the AB and AC Cordia have two different setups (1x large and 1x small injector, or 2x same size injectors), but I'm not sure which model years are the AC or AB, but my setup is likely to be similar, if not identical to the later model ones, or does only Starion have this setup?

Sorry, I don't know much about Cordia's at all :P

Author:  Bitza [ 13 Feb 2018, 16:58 ]
Post subject:  Re: Injector advice

AA, AB 1983 to 1985 run the black top injectors (800cc), AC 1986 to 1988 run the grey tops (750cc), hope this helps.

Author:  ScrubbRacer [ 18 Feb 2018, 18:47 ]
Post subject:  Re: Injector advice

Bitza wrote:
AA, AB 1983 to 1985 run the black top injectors (800cc), AC 1986 to 1988 run the grey tops (750cc), hope this helps.


Thanks Bitza, this should help a lot. When you say grey & black top injectors, is it the connector colour or something else? I haven't had my throttle body apart, nor am I familiar with them :P

Page 1 of 1 All times are UTC + 10 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/