Same with the TPS/ISC FAQ the pics arent showing up. Could someone update the pics as it would be awesome to perform this conversion.
Thanks

_________________
White '86 AC GSR

*bump* anyone?

_________________
White '86 AC GSR

same here, im getting the gauges soon and it would be really helpful if there was a useful write up to follow, would save alot of time and it would get dont right first time for once.
Could someone who has done the conversion maybe do a write up dosent even need pics, im more worried about removing the dash, thats the bit where im not sure where to start.
Cheers

_________________
KIZZA **BoOsT oR NufFiN**

hay im not to sure about the thread your askin, is if changing the face dials over if so ive done it and will tell you how if thats what u are after

Hey ive worked out how to get the cluster out and the essentially get to the guages.. but how do you take the faces off?
For the record this is the thread:
http://www.cordiapower.com/forum/viewtopic.php?t=7621

_________________
White '86 AC GSR

hay once u get the plastic cover of which is held on with clips then carefully hold the bits of plastic, taco etc with out pushing down on them srew them of with a small screwdriver but when u are doing this hold u finger at the bottom of the screw as it will fall out of place very hard to align back up were as if you keep it in place it just screws straight back up easy peasy. when u done it make sure u dont push the taco dial etc down to hard otherwise it wont move and u normally dont no this until u put the holw god damn thing back together then u have to start again.TRUST ME i no

oh so the needles pull straight off? i thought i read somewhere they were stuckon pretty well with glue. maybe i mis read it. Do you need to print the faces onto special paper or is standard paper fine?

_________________
White '86 AC GSR

no the needles pull straight of but be very careful doing it.

Im not sure about printing the faces on certain paper i brought my white faces already done they are made of soft rubber.

im just not sure how to get the cluster itself out.

_________________
KIZZA **BoOsT oR NufFiN**

there are 4 screws to get the dash cover off. 2 up in the cluster (top edge) and 2 on the bottom edge one under the fan control and one near the ign barrel
there is also a plug that may or may not help but it might pay to remove it.
pull the top gently towards you until it releases
then pull the left side and the whole thing should pop off. if not wiggle it around tilit does.
then there are the two switches - disconnect those.
cluster there are 2 screws on top they are pretty obvious. same with the 2 bottom ones.
the cluster can now be pulled out a bit. disconnect speedo cable and the 3 or 4 wiring blocks.

to get to the faces take off the clear plastic by pushing in the clear tabs.
once removed push the grey/black tabs in and this will expose the faces.


wow thats an faq in itself.... and pretty similar to the one thre. hope they help. let me know if u need pics

_________________
White '86 AC GSR