hey guys, i was wondering if n e one had seen piller mouldings for guages to fit cordias... you kno the ones i mean....

i havent seen any narrow enough or specifically made for em... any ideas?

scott

_________________
'70 XW GT, STOCK! (as stock as GT's are)
'94 Silver Evo 2, ross forged pistons, eagle H-Beam rods, Garrett roller bearing turbo, ceramicoated manifold, 272 cams, copper head gasket, 450x300 FMIC, 3" exhaust w/HKS cannon, king springs, 17" rims, Strut brace.

ive seen some at Autobarn...they are labelled as "universal fit" but wether they are or not i really would not know. they also look a little cheap, but some paint and little mods and theyd look as good as Autometer.
Jon

Whip out the fibreglass and start moulding mate

I doubt you'll find anything to fit a cordia that isn't a dodgy universal job or a custom job.

Astaroth.

_________________
[size=75]Ich will die Ruhe stören

Bones heal, chicks dig scars, glory lasts forever.

Or u could find a pvc pipe with the right diameter for ur gauge, then cut and heat and bend the other end till it fits right. Then u paint it

Im talking about the thing they did at autospeed.com, ill see if i can find it.
Here 'tis:
http://www.autospeed.com/cms/A_0078/article.html

Just a bit easier, and prolly cheaper, than fiberglass... might not look as good tho.

-Loss

_________________
Think of the average person. Half the people in the world are below that.