Hey Guys,
Cordia's just getting too old and too costly to fix up, so I'm separating some bits off. First off the line is the exhaust. Full 2.5" exhaust - single muffler, single cat, low-radius bends (press bent though). Plus my dump pipe. This one has a separate wastegate pipe which joins back in about a meter down the pipe length - just before the flex joint. See pictures. (It connected up to a TD05 turbo).
I wouldn't think the oxygen sensor works - I assume it's pretty dirty with carbon/oil smoke. I never had it connected so don't know.
The turbo sounds from this are amazing... all the fluttering, whistling and whooshing you could want.
Exhaust - $300 (Think the exhaust its stainless as there isn't much surface rust.)
Dump Pipe - $200
I'm in Perth, WA (NOR)
It's off a VR4 Cordia (with a Wolf3d). VR4 has valve-train rattle and smokey/rough start-up, but once warmed up runs fine. If anyone in Perth wants the car let me know too - I'll be scrapping it soon. It's not rego'd so would need to be trailered. The steering is wobbly and the body average, so it's only good for transplanting a working VR4 setup to a nicer body.
| Attachments: |
|
exhaust2.JPG [ 136.48 KiB | Viewed 5463 times ] |
|
dumppipe2.JPG [ 155.18 KiB | Viewed 5463 times ] |
|
dumppipe1.jpg [ 141.55 KiB | Viewed 5463 times ] |
, and I need to keep the car mobile, so if anyone is interested for the whole car (working example of VR4 setup (but note comments in my original post), rear disk brakes, etc) then PM me / post here. You need to take the whole car though.